Symantec™ Embedded Security: Critical System Protection v6.5.1 MP1

Products

• Embedded Security Critical System Protection

Issue/Introduction

 

Resolution

Symantec has released Embedded Security: Critical System Protection (SES:CSP) v6.5.1 MP1. This release resolves issues reported by customer and few internal defect fixes. This release supports an upgrade path to v6.5.1 MP1.

Issue	Resolution
Summary graph shows inaccurate numbers of agent statistics for online and offline agents.	This issue is fixed.
Update policy wizard stops responding when you try updating a policy.	This issue is fixed.
A read-only registry key that had prevention applied could be deleted from the registry editor.	This issue is fixed.
Policy folders or policies are not listed when you right-click an asset group or directory or folder under Assets tab.	This issue is fixed.

Upgrade support matrix for agent and management server

You can upgrade the agent and the management server to a higher version. The following table provides the upgrade support matrix for the agent and the management server.

Current Version	Upgrade To
Symantec Embedded Security: Critical System Protection 6.5.0 (MP1)	Symantec Embedded Security: Critical System Protection 6.5.1 MP1
Symantec Embedded Security: Critical System Protection 6.5.1	Symantec Embedded Security: Critical System Protection 6.5.1 MP1
Symantec Embedded Security: Critical System Protection 1.0.1 (MP5)	Symantec Embedded Security: Critical System Protection 6.5.1 MP1

Points to remember:
If you are upgrading the management server and the agent, upgrade the components in the following sequence:

1. Management server
2. Agent

Symantec Embedded Security: Critical System Protection does not support upgrading the management console. However, the management server and management console must be the same version. Therefore, you must uninstall the existing management console and then install the version of the management console that is the management server.