ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.

How to remove an 'IN USE BY' indicator flag for a CA Telon program

book

Article ID: 14980

calendar_today

Updated On:

Products

Telon Application Generator

Issue/Introduction



Receiving the following message:
IN USE BY ONLINE PROGRAM DEFINITION MENU ****** ** SCREEN IS CURRENTLY IN USE BY ULAG1

How do I remove/reset the above "in use by" indicator?

Environment

Release: ESBTLN99000-5.1-Telon-Extended Support Basic
Component:

Resolution

This can be accomplished online from the TDF INSTALL panel with issuing one of the following commands:
* LI WF
* LI WD
* LI WX

If you see a record that is not attached to a current user, please put a Z (zap) by the specific member or members which you would like to be deleted.

Or, this can be accomplished by running our JREORGWK batch job, found in the pdsqual.INSTALL library.

This job is best run after hours, as exclusive use of the VSAM files is needed and all users will therefore need to be logged off of the TDF.

A Delete/Define and reinitialize of the WIP files will then be done, releasing the specific member/members for you.

 

Powered by Wolken Software