Installing new FMID/CD71B40 into an existing CSI

book

Article ID: 14662

calendar_today

Updated On:

Products

CA Mainframe Software Manager (Chorus Software Manager)

Issue/Introduction



What is the process to get a new FMID for example  CD71B40 to be pulled into CA CSM, under the existing product/WORKLOAD AUTOMATION ESP 11.4 product we already have in CA CSM?  

Environment

Release: MSMNGR00200-5.1-Chorus Software Manager
Component:

Resolution

All FMID's are included in the install package from which the product was initially installed so this same install package can be used to install the new FMID. Using CD71B40 as an example. The first step is to ensure that your CSI is in your working set. To do this please click the SMP/E Environment tab. Check off the CSI and where it says select and: use as working set, click ‘use as working set’

<Please see attached file for image>

src="/servlet/servlet.FileDownload?file=0150c000004AKWIAA4" alt="SNAG1png.png" width="636" height="145">

Next click the products tab and click CA Workload automation ESP edition – MVS then click the + in front of 11.4 then click either 0000 or S1609. This should display the install packages. CD71B40 FMID is in the install package highlighted below

<Please see attached file for image>

src="/servlet/servlet.FileDownload?file=0150c000004AKWHAA4" alt="SANG2.png" width="632" height="207">

Click the actions button to the right then click install. That displays the base install wizard.  Click next.

<Please see attached file for image>

src="/servlet/servlet.FileDownload?file=0150c000004AKWJAA4" alt="SNAG3.png" width="636" height="266">

Check off Custom installation and then click next.

<Please see attached file for image>

src="/servlet/servlet.FileDownload?file=0150c000004AKWKAA4" alt="SNAG4.png" width="641" height="550">

Check off CA Workload automation ESP HAO then click next, then next again to bypass the prerequisites, there are none.

<Please see attached file for image>

src="/servlet/servlet.FileDownload?file=0150c000004AKWLAA4" alt="SNAG5.png" width="632" height="299">

Check off your CSI for workload ESP. It will be listed here because it is in your working set. It always defaults to Create a New SMP/E Environment. In  this case I checked off barra01 WL ESP 11.4 and click next.

<Please see attached file for image>

src="/servlet/servlet.FileDownload?file=0150c000004AKWMAA4" alt="SNAG6.png" width="636" height="279">

From this point on just click next until the install button becomes active.

Attachments

1558709263700000014662_sktwi1f5rjvs16rfm.png get_app
1558709261952000014662_sktwi1f5rjvs16rfl.png get_app
1558709260264000014662_sktwi1f5rjvs16rfk.png get_app
1558709258525000014662_sktwi1f5rjvs16rfj.png get_app
1558709256777000014662_sktwi1f5rjvs16rfi.png get_app
1558709254840000014662_sktwi1f5rjvs16rfh.png get_app