Changing RETRIEVE PF Key back to PF06 on Netmaster 12.2 Command Entry screen
book
Article ID: 145967
calendar_today
Updated On:
Products
CMDB for z/OSNetSpy Network PerformanceNetMaster Network AutomationNetMaster Network Management for SNANetMaster Network Management for TCP/IPNetMaster File Transfer ManagementSOLVE
Issue/Introduction
On the "Command Entry" screen for Netmaster 12.1, PF6 was set to Retrieve and PF12 to Refresh. On 12.2, the setting are the following instead: F6=Refresh F12=Retrieve Is it possible to set PF6 back to Retrieve?
Environment
Release : 12.2
Component : CA NetMaster Network Management for TCP/IP
Cause
PTF SO01868 has changed the settings for OCS and Command Entry as different products (e.g. ISPF and CA SYSVIEW) use PF12 for Retrieve.
Resolution
The "Command Entry" PFkeys setting cannot be changed as this is hardcoded in the NCL code that deals with the screen.
Additional Information
The OCS settings can be changed instead, see HOLD instructions on SO01868