ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
DCI Agent gets S0C4 and DCI2005E MAX RESTARTS OF LPI TASK REACHED
book
Article ID: 145952
calendar_today
Updated On:
Products
Dynamic Capacity Intelligence
Issue/Introduction
CA Dynamic Capacity Intelligence 2.0 has been just installed on a zPDT system.
Controller region starts up fine but the Agent region starts but it doesn't initialize and after some minutes it closes due to: DCI2005E: MAX RESTARTS OF LPI TASK REACHED
The Agent JESMSGLOG shows that there were 3 S0C4-04 in ZDCA0001 @x'1E8A' at the same exact time when DCILOG showed: DCI2310I: AGENT LPI TASK STARTUP IN PROGRESS DCI2311I: AGENT LPI TASK STARTUP COMPLETED
Cause
CA Dynamic Capacity Intelligence cannot be installed on zPDT systems or on z/OS guest under VM.
Environment
Release : 2.0
Component : CA DYNAMIC CAPACITY INTELLIGENCE
Resolution
DCI is only supported on native, non-simulated z/OS running on real z hardware
Additional Information
See also the following sections on DCI 2.0 documentation: