ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
UMP http to https redirect not working - Status 404
Article ID: 145859
Updated On:
Products
NIMSOFT PROBES
DX Unified Infrastructure Management (Nimsoft / UIM)
Issue/Introduction
UMP Logon via HTTP shows the following error with "Automatic HTTP to HTTPS Redirect" settings configured
page:
HTTP Status 404 - Not found error
Cause
The <UMP or UIM server_installation>/Nimsoft/probes/service/wasp/webapps/ROOT/WEB-INF/web.xml is not properly configured
Environment
Release : 9.2.0
Component : UIM - UMP
Resolution
Make sure that <security-constraint> section is properly added to the webex.xml file per documentation -> (UMP Only) Set Automatic HTTP to HTTPS Redirect
https://techdocs.broadcom.com/content/broadcom/techdocs/us/en/ca-enterprise-software/it-operations-management/unified-infrastructure-management/8-5/installing-ca-uim/optional-post-installation-tasks/configure-https-in-admin-console-or-ump.html#concept.dita_687aa711bc3c77d86f488db5801dd34ebf433277_HTTPSRedirectandAdminConsole
https://techdocs.broadcom.com/content/broadcom/techdocs/us/en/ca-enterprise-software/it-operations-management/unified-infrastructure-management/8-5/installing-ca-uim/optional-post-installation-tasks/configure-https-in-admin-console-or-ump.html#concept.dita_687aa711bc3c77d86f488db5801dd34ebf433277_HTTPSRedirectandAdminConsole
Feedback
Yes
No
Powered by
