After upgrading to CA View 14, Jobtrac 0 line command opens incorrect job output in the CA View interface

Products

• Jobtrac
• View

Issue/Introduction

After recent upgrade to CA View 14, the Jobtrac  line command 0 will open CA-View but does not open to the job output requested.

CA Views interface for sysout selection via a JOBTRAC panel is receiving 'NO SYSOUT SELECTED' when issuing '0' on current completed job.                                                

Environment

Release : 14.0

Component : CA View

Resolution

The problem only occurs when executing code from the initial (GA) release View 14.0 load library.  If you point to an older View 14.0 loadlib (like INC01), the problem does not occur.

CA View PTF's SO12307 and LU01553 should be applied to correct the problem.

A circumvention to the problem in Jobtrac would be to point back to the previous release of your CA View load library in the TSO logon proc.  There is no circumvention using the affected interface, however users can logon to CA View and pull up the job information.

As always, please contact Broadcom support for Jobtrac Job Management if you have further questions.