AWI: Show in Process Monitoring sets Agent name to Task, not to Agent

Products

• CA Automic Workload Automation - Automation Engine

Issue/Introduction

In the 12.3.1 Automic Web Interface, when going to the Monitoring perspective via Administration -> Agents -> right click / Monitoring / Show in Process Monitoring, the activities are not displayed.

The Process Monitoring filter is set to Task Name = <Agent Name>, but the Task Name should be blank and the Agent Name = <Agent Name>

Environment

Release : 12.3

Component : AUTOMATION ENGINE

Cause

A problem has been solved where the wrong filter criterion was set with the Monitoring>Show in Process Monitoring function for Agents. Instead of populating the Agent Name field in the Process Monitoring filter, the Task Name field was populated with the name of the Agent. This led to wrong filter results. With this fix, the Monitoring>Show in Process Monitoring function for Agents uses the expected filter criterion, namely, Agent name.

Resolution

This has been resolved in:

Automic.Web.Interface 12.3.2