Generating Automations Scripts for Complex Flows Not Happening
Article ID: 145732
Updated On:
Products
CA Agile Requirements Designer
Issue/Introduction
Generating automations scripts for complex flows are not happening.
Have a series of models model with 200 test cases, each script is ~1322, paths going through ~10 subflows which are up to 2 levels deep.
Have spent a lot of time manually deleting test cases so that to export the 200 scripts into smaller numbers. To avoid a project being delayed to from moving to production by ARD.
Tried to avoid models reaching this level of complexity but this is going to become an increasingly common problem as more and more of the application functionality gets modelled.
Have a series of models model with 200 test cases, each script is ~1322, paths going through ~10 subflows which are up to 2 levels deep.
Have spent a lot of time manually deleting test cases so that to export the 200 scripts into smaller numbers. To avoid a project being delayed to from moving to production by ARD.
Tried to avoid models reaching this level of complexity but this is going to become an increasingly common problem as more and more of the application functionality gets modelled.
Environment
Release : 2.11
Component : CA Agile Requirements Designer
Cause
Code defect.
Resolution
Open a new support case and refer to defect DE439282
Feedback
Yes
No
Powered by
