ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
AWI - Where are the tabs v12.3?
Article ID: 145473
Updated On:
Products
CA Automic Workload Automation - Automation Engine
CA Automic Workload Automation - Automation Engine
Issue/Introduction
In v12.0 to v12.2 a new tab was opened in Automic Web Interface (AWI) when an object was opened. This behavior changed in v12.3.
Starting from v12.3 right clicking an object will open the object in the same tab. This is the new design.
Starting from v12.3 right clicking an object will open the object in the same tab. This is the new design.
Cause
The design of AWI was changed to unleash the power that is built into Web Browsers like Chrome, Firefox and Edge.
Environment
Release : 12.3
Component : AWI
Resolution
You can read about the new AWI concepts here, under the header New Navigation Paradigm:
https://docs.automic.com/documentation/webhelp/english/AA/12.3/DOCU/12.3/Automic%20Automation%20Guides/help.htm#_Common/ReleaseHighlights/RH_AWI.htm?Highlight=New%20Navigation%20Paradigm
In short: To open separate tabs use the middle click of your mouse
https://docs.automic.com/documentation/webhelp/english/AA/12.3/DOCU/12.3/Automic%20Automation%20Guides/help.htm#_Common/ReleaseHighlights/RH_AWI.htm?Highlight=New%20Navigation%20Paradigm
In short: To open separate tabs use the middle click of your mouse
Attachments
Feedback
Yes
No
Powered by
