Unable to open netapp probe configuration
Article ID: 145361
Updated On:
Products
DX Unified Infrastructure Management (Nimsoft / UIM)
Issue/Introduction
Unable to open netapp probe configuration from IM and and then there will be a popup window with:
Environment
UIM 20.3 and later
netapp 1.3 and later
Resolution
Probes are typically run on robots that connect to a hub which connects to the primary hub. For the netapp probe, the following best practice is suggested for selecting maching configuration for the robot that runs them:
= Machine type - physical or virtual (VM)
= HA Configuration - not required
= Machine CPU Computer - 2 to 4 core 64-bit Pentium or equivalent with speed of 2.0 Ghz with 50% available on average
= Machine system memory - 4 to 6 GB
= Machine disk storage - 10 GB available
= Machine Network bandwidth - standard LAN connectivity bandwidth, typically 1 Gbps. For better results, the robot machine should be in the same subnet as the devices monitored by the probes running on that robot.
= Operating Systems - all robot supported OS
= Machine type - physical or virtual (VM)
= HA Configuration - not required
= Machine CPU Computer - 2 to 4 core 64-bit Pentium or equivalent with speed of 2.0 Ghz with 50% available on average
= Machine system memory - 4 to 6 GB
= Machine disk storage - 10 GB available
= Machine Network bandwidth - standard LAN connectivity bandwidth, typically 1 Gbps. For better results, the robot machine should be in the same subnet as the devices monitored by the probes running on that robot.
= Operating Systems - all robot supported OS
Attachments
Feedback
Yes
No
Powered by
