ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
Execution paging - selection will be reset when navigating back after seeing a job report
Article ID: 145241
Updated On:
Products
CA Automic Workload Automation - Automation Engine
Issue/Introduction
It is inconvenient when browsing executions list and open a lot of executions' report due to the selection will be reset upon navigation,
For example:
- Open a list of executions
- Select one execution (highlight an entry)
- Open its report
- Return back to the executions list
Expected behavior:
- Selection is kept
Actual behavior:
- Selection is lost, it reset as if opening a new executions list
Cause
New paging mechanism of Automic.Web.Interface 12.3
Environment
Release : 12.3
Component : ACTION BUILDER
Resolution
Workaround: open report in new browser tab with middle-click to avoid navigating forth and back.
Additional Information
To be raised as an idea
Feedback
Yes
No
Powered by
