Cannot Verify Automic Job Ran
book
Article ID: 145012
calendar_today
Updated On:
Products
CA Automic Workload Automation - Automation Engine
Issue/Introduction
Automic admin submitted a job, but when they click on the "Executions" button, they get the following error:
Message box received: 4006529 of type W with inserts shown, message 'This task is not yet active or not active anymore.'.
Environment
Release : 12.3
Component : ACTION BUILDER
Cause
The job already completed.
Resolution
The Message:
Message box received: 4006529 of type W with inserts shown, message 'This task is not yet active or not active anymore.'.
Means that the job has already completed! So if you are trying to go into executions you will get this message.
If you go to where your job is defined and click on "Last Report" - it will advise the standard output from the job.
Feedback
thumb_up
Yes
thumb_down
No