Dynam support for Load Display with DLM
Article ID: 144961
Updated On:
Products
Dynam for VSE
Dynam VSE Option
Issue/Introduction
We are migrating to a DLM migration. The Dell group wants to know if Dynam supports 'Load Display' CCW?
Environment
Release : 7.1
Component : CA-DynamT for VSE
Resolution
Dynam/T does issue the load display CCW to put volser/volume status etc... information to the display area.
There are two Dynam/T system options that control load display actions. LCD=YES/NO tells Dynam/T whether or not to issue the load display (X'9F') CCW command. There is also another option to display info in the second readout area called FLIP=NO/JOBN/ID which is only valid if LCD=YES is specified.
There are two Dynam/T system options that control load display actions. LCD=YES/NO tells Dynam/T whether or not to issue the load display (X'9F') CCW command. There is also another option to display info in the second readout area called FLIP=NO/JOBN/ID which is only valid if LCD=YES is specified.
Feedback
Yes
No
Powered by
