IF workflow does not save dependencies.

Products

• CA Automic Workload Automation - Automation Engine

Issue/Introduction

Put a dependency on the END object of an IF workflow.



Save the workflow object, close it and open it again, the dependency is gone.

Environment

Release : 12.3

Component : AUTOMIC WEB INTERFACE

Cause

Defect

Resolution

Update to a fix version listed below or a newer version if available.

Component: Automic Web Interface

Automic Web Interface 12.3.3 - Available

Public short description EN:
"IF" WF does not save conditions on end object

Public description EN:
A problem has been fixed where the status of a condition on the END object of an IF workflow was not shown in the dependencies table.

Additional Information

Workaround:

This works with the Java UI, which is not supported anymore and should only be used with caution.