XNET fails to start as a started task (STC) due to RACF permission errors
search cancel

XNET fails to start as a started task (STC) due to RACF permission errors

book

Article ID: 144714

calendar_today

Updated On:

Products

Database Management for DB2 for z/OS - Administration Suite Database Management for DB2 for z/OS - Performance Suite Database Management for DB2 for z/OS - Recovery Suite Database Management for DB2 for z/OS - SQL Performance Suite Database Management for DB2 for z/OS - Utilities Suite DATABASE MANAGEMENT SOLUTIONS FOR DB2 FOR Z/OS

Issue/Introduction

Attempts to start Database Management for Db2 for z/OS XNET as a started task fails.  However, it successfully starts as a batch job.
As a STC it encounters RACF errors on allocated datasets.

Cause

RACF definitions needed to be supplied for the datasets being accessed by XNET.

Resolution

Correcting the RACF setup for the UID associated with the XNET STC and the ability to access its datasets proved successful.
Powered by Wolken Software