ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
BUSGRP DOES NOT SHOW EVENTS
Article ID: 143816
Updated On:
Products
Jobtrac
Issue/Introduction
When using the BUSGRP command and selecting a particular group from location 002 no jobs are shown.
TRACAUTH was updated to include location 002.
Using the AUTH command show location 002 as (REMOVED)
Cause
The TRACAUTH table was assembled but the LLA had not been refreshed.
Environment
Release : 11.0
Component : JOBTRAC
Resolution
After reassembling the TRACAUTH table:
1) Issue the command F LLA,REFRESH
2) Issue the command F jobtrac,AUTH where jobtrac is the name of the CA Jobtrac started task
3) Logoff and logon TSO user
Feedback
Yes
No
Powered by
