cdm probe mcs message definitions error

Products

• DX Unified Infrastructure Management (Nimsoft / UIM)

Issue/Introduction

cdm probe configured from UMP USM portlet monitoring tab option

While opening the cdm probe message definitions in Infrastructure Manager can observe the below error for some message definitions where there is mismatch of alert severities

 

Environment

Release : 8.51

Component : UIM - CDM WITH IOSTAT

cdm-mc versions

Resolution

If using the IM one should use IM only for all configuration and same goes for MCS and Admin console.
Currently its not supported for inter-related changes which means in case you made configuration in MCS it is not sure that IM will support all features present and this is what happening in this scenario.
As clear severity is not supported in IM till now we see above error messages and hence recommended to stick to one UI only for configuration changes.