UIM - Special characters not working for iSeries probes
Article ID: 143038
Updated On:
Products
DX Unified Infrastructure Management (Nimsoft / UIM)
Issue/Introduction
Do iSeries probes support localization?
if the characters "å ä ö Å Ä Ö" appear in an alarm messages for any of the iseries supported probes it translates to "å U 6 Å D O".
Environment
Release : 9.0.2
Component : UIM iSeries supported probes
Cause
No support for localization
Resolution
None of the iSeries probes have official support for localization.
No workaround is available.
Feedback
Yes
No
Powered by
