Netmaster region gets "RMINWI96 Could not restart the SYSLOG daemon" at system initialization
Article ID: 143033
Updated On:
Products
Issue/Introduction
Netmaster 12.2 joblog contains the following errors on JESMSGLG:
IAIN0167 (NETMAST) parameter group $RM SYSLOGD failed. Error message follows
RMINWI96 Could not restart the SYSLOG daemon
IAIN0143 (NETMAST) Initialization failures have occurred
In addition, the following messages are output via the LOG1 DD statement;
IAIN0126 Processing for parameter group $RM SYSLOGD started
IAIN0124 Global variable GLBL$RMSLLOG set to "YES"
RMINWI95 SYSLOGD Message Interface is enabled
RMINWI95 Pipe receiver started
RMINWI95 Syslog daemon process id is 33687285
RMINWI95 Signaling daemon: kill -s hup 33687285
RMINWI95 kill: 33687285: EDC5139I Operation not permitted.
RMINWI95 Syslog daemon must be restarted
RMINWI96 Could not restart the SYSLOG daemon
IAIN0178 Processing for parameter group $RM SYSLOGD ended, status is FAILED
IAIN0112 Action of parameter group $RM SYSLOGD FAILED
IAIN0113 Processing for phase INIT completed, 1 failures
IAIN0143 (NETMAST) Initialization failures have occurred
Environment
Release : 12.2
Component : CA NetMaster Network Management for TCP/IP
Cause
This is an External Security authorization problem. The Netmaster region STC userid does not have the correct authorization to kill the SYSLOGD process.
Resolution
Add READ access for SUPERUSER.PROCESS.GETPSENT and SUPERUSER.PROCESS.KILL to the USS privileges of the external security system for the Netmaster userid so that it can restart SYSLOGD during region initialization.
Feedback
