ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.

How to configure snmp timeouts and retries for a device?

book

Article ID: 142650

calendar_today

Updated On:

Products

CA Infrastructure Management CA Performance Management - Usage and Administration DX NetOps

Issue/Introduction

Where do I configure SNMP timeouts and Retries for a device?

Environment

Dx NetOps Performance Management 20.2

Resolution

SNMP Timeouts and retries are configured in the SNMP profile as noted here:

Please note that a REST client is needed, and a customer header needs to be created in the REST client, as follows

Header name: content-type

Value: application/xml

https://techdocs.broadcom.com/us/en/ca-enterprise-software/it-operations-management/performance-management/20-2/building/snmp-profiles.html#concept.dita_d5acf4642dd2294090d5c2e1150882aea566cf5e_ModifytheTimeoutandRetriesParameters

https://techdocs.broadcom.com/us/en/ca-enterprise-software/it-operations-management/performance-management/3-7/snmp-profiles.html#concept.dita_d5acf4642dd2294090d5c2e1150882aea566cf5e_ModifytheTimeoutandRetriesParameters

You would set up the desired values in the SNMP profile and assign that to the device on the Data Aggregator device administration page and/or discover the device using that SNMP profile

Powered by Wolken Software