Endevor Quickedit - 'ENDE090E The FTINCL service passed a RC of X'00000008'

Products

• Endevor
• Endevor Natural Integration
• Endevor - ECLIPSE Plugin
• Endevor - Enterprise Workbench

Issue/Introduction

Quickedit sometimes gets 'ENDE090E The FTINCL service passed a RC of X'00000008' (ENDIE700).  Sometimes it gets the same message number but says FTOPEN (instead of FTINCL).

Resolution

For the FTOPEN error - These are the situations that can result in that error :
- That error can result from a space problem under Quickedit - If the users work or list dataset is to small, it can be increased from the Quickedit Dialog Defaults panel, off the Quickedit main panel.
- check the DCB of the CSIQSENU in your CLIST concatenation.
- problem with user's PFkeys

As for the FTINCL error - these are usually seen if there is a problem with a skeleton or for some reason you are mixing releases. It could also be a problem opening skeleton library (CSIQSENU) member. Check concatenation of panel/skeleton libraries. Check the skeleton- make sure everything is correct.