Configure dynamic thresholds in UIM for cpu memory using MCS

Products

• DX Unified Infrastructure Management (Nimsoft / UIM)

Issue/Introduction

Can configure dynamic thresholds in UIM for cpu memory using MCS? While using just  normal mcs profiles such as setup cdm ,disk(s), memory monitor etc. (But not  using MCS enhanced profiles)

 

Environment

Release : DX UIM 20.x.x

Component : UIM - CDM WITH IOSTAT

cdm - 6.42-MC and higher

cdm_mcs_templates - 6.42 nd higher

Cause

Guidance

Resolution

If you're using MCS, and you want to configure dynamic thresholds for the cdm probe, you MUST use enhanced profiles.

Refer to: 
Configuring Alarm Thresholds in MCS (broadcom.com)

Please read/review the info at the url above for complete information as well as FAQs.