ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.

Can we configure dynamic thresholds in UIM for cpu memory using MCS?

book

Article ID: 142491

calendar_today

Updated On:

Products

DX Unified Infrastructure Management (Nimsoft / UIM)

Issue/Introduction

Can we configure dynamic thresholds in UIM for cpu memory using MCS?

We are NOT using MCS enhanced profiles . We are just using normal mcs profiles such as setup cdm ,disk(s), memory monitor etc. 

Cause

- question

Environment

Release : 9.1.0

Component : UIM - CDM WITH IOSTAT

cdm - 6.42-MC

cdm_mcs_templates - 6.42

Resolution

If you're using MCS, and you want to configure dynamic thresholds for the cdm probe, you MUST use enhanced profiles.

As of UIM v9.0.2 or higher, please refer to:

Configuring Alarm Thresholds in MCS
https://techdocs.broadcom.com/content/broadcom/techdocs/us/en/ca-enterprise-software/it-operations-management/unified-infrastructure-management/9-0-2/configuring-alarm-thresholds-in-mcs.html

Please read/review the info at the url above for complete information as well as FAQs.

Powered by Wolken Software