Autorep command in WCC ECLI gives error: method not found

Article Id: 142291

Status: Published

Updated On: 24-12-2019 12:05

Products:

CA Workload Automation AE - Business Agents (AutoSys) , CA Workload Automation AE - System Agent (AutoSys) , CA Workload Automation AE - Scheduler (AutoSys) , CA Workload Automation Agent , CA Workload Automation AE

Issue/Introduction:

When trying to execute an autorep command in WCC ECLI, following message is produced:

The command could not be executed. Command processing exception encountered.

Error: method not found

Environment:

Release : 11.4

Component : WORKLOAD CONTROL CENTER

Resolution:

Some binaries of the Command Sponsor were missing under $IGW_LOC directory on the Autosys server.

Required to reinstall the Command Sponsor again using following steps

cd /opt/CA/WorkloadAutomationAE/CommandSponsor
./WCC_CommandSponsor.bin