Increase the end of record totals in TSSAUDIT CHANGES report

Products

• Top Secret
• Top Secret - LDAP

Issue/Introduction

The 'TOTALS' output fields only display 5 digits and now to increase it.

At the end of a TSSAUDIT CHANGES report, the 'TOTALS' output fields only display 5 digits.
This causes a misleading count if CA Top Secret Recovery File size allows more than 99,999 commands.

Environment

z/OS

Resolution

CA Top Secret 16.0 PTF RO93744 introduced an enhancement that a TSSAUDIT CHANGES report increase the size of the record counts displayed at the end of the report. The count is currently a 5 digit value, this change increases it to a 9 digit value. 

Just run a TSSAUDIT CHANGES report and you should see the difference as follows.     
                                                     
* CURRENT:                                                                   
 ----- LISTING OF CHANGES TO SECURITY FILE -----
                                              
         ALL CHANGES WITHIN SCOPE LISTED       
                                              
           TSS COMMAND CHANGES = 02323         
                PASSWORD CHANGES = 00013          
                     PHRASE CHANGES = 00000         
                    DYNAMIC UPDATES = 00000                

* ENHANCED (After applied PTF RO93744):      
 ----- LISTING OF CHANGES TO SECURITY FILE -----
                                              
         ALL CHANGES WITHIN SCOPE LISTED       
                                              
       TSS COMMAND CHANGES = 000002323         
            PASSWORD CHANGES = 000000013          
                 PHRASE CHANGES = 000000000         
                DYNAMIC UPDATES = 000000000