ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.

Resource reservation issue when using hostgroup

book

Article ID: 141489

calendar_today

Updated On:

Products

CA Automic Workload Automation - Automation Engine

Issue/Introduction

The following issue happens sporadically:
 
Setup a HOSTG with 2 Agents and Load dependent
Set WORKLOAD_MAX_JOB=10 in UC_HOSTCHAR
Create a JOBS with the HOSTG
In Preproces set:
  • :PUT_ATT RESOURCE_CONSUMPTION = '1' and Generate at Activation Time (Attributes)
    • RUN -> OK
  • Set :PUT_ATT RESOURCE_CONSUMPTION = '15' and Generate at Activation Time
    • RUN -> Waiting for Host, as expected
  • Set :PUT_ATT RESOURCE_CONSUMPTION = '15' and Generate ar Runtime
    • RUN -> Waiting for Host, as expected
  • Set :PUT_ATT RESOURCE_CONSUMPTION = '1' and Generate ar Runtime
    • RUN -> Waiting for Host, *NOT* as expected

Cause

Resources for a job were reserved twice if :PUT_ATT RESOURCE_CONSUMPTION is used in Pre-process

Environment

Release : 12.3

Component : AUTOMATION ENGINE

Resolution

Issue is fixed in the following releases:

  • Automation.Engine 12.2.5 - Available
  • Automation.Engine 12.3.1 HF1 - Available
  • Automation.Engine 12.3.2 - Available
 
Powered by Wolken Software