MESSAGES IPVP1101 MONITORING VIPA DISTRIBUTOR

book

Article ID: 141147

calendar_today

Updated On:

Products

CA NetMaster Network Management for TCP/IP

Issue/Introduction

Cust reported thus:
 
For a VIPA distributor defined on LPAR SYSA it is being issued the following message  on each monitoring
cycle of 10 minutes:
 
IPVP1101 No managing region available on LPAR SYSB           
 
 
These NetMaster instances communicate between them via INMC link--but are not with associated images
(linked). Are additional changes necessary?
 
-

Cause

-

Environment

OS : z/OS

Release : 12.2

Component : CA NetMaster Network Management for TCP/IP

Resolution

NetMaster Level 2 Support provided these remarks for the solution (note: AA etc.  are changed

from  the original):

-

 

Regions must be Linked and Synched in order for regions to determine remote LPAR statuses. 

 

Just reproduced the following on AAAA9 and AAAA30--even though I have           an INMC link

(which is what cust have):

 

IPVP1101 No managing region available on LPAR AA31

IPVP1101 No managing region available on LPAR AA31

 

We have an ACTIVE link but it is not Linked and Synched:

 

SH LINKS=ALL  

N13505 --LINKNAME-- -STATUS- MODE MSGID --NODE-- TYPE PEER -TIME DIFF-  

N13506 AAAA30 ACTIVE S AAAA AAAA30 STAT HOST +00:00:00.00  

N13523 SESS#....1 ACTIVE  

N13524 TOTALS: STATIC LINKS= 1 DYNAMIC LINKS= 0 DYNAMIC LIMIT=99  

 

When it was Linked and Synched that message didn't come out -- so the regions need to be

Linked and Synched before this information can  work itself out.

 

-

Additional Information

From the NetMaster doc--at the techdocs.broadcom.com site:
-
 
IPVP1101
 
No managing region available on LPAR P1
 
Reason:
 
The VIPA makes use of a stack on LPAR P1 but there is no NetMaster region on this LPAR
to provide management information.
 
System Action:
 
The information for this LPAR is not obtained.
 
User Action:
 
Check the status of the NetMaster region on LPAR P1.
 
-