2932 ARCHIVE/BACKUP FAILED FOR DSN=xxx.xxx
search cancel

2932 ARCHIVE/BACKUP FAILED FOR DSN=xxx.xxx

book

Article ID: 140931

calendar_today

Updated On:

Products

DISK BACKUP AND RESTORE

Issue/Introduction

Following errors received during Archive / Backup.

2932 ARCHIVE/BACKUP FAILED FOR DSN=xxx.xxx

IEC032I E37-08,IFG0554P,userid,DMS,ARCHIVE0,6A33,DMS202,041A041D,  285
BBBB.xxx.DMS.xxx.DMSC.Dxxx.Txxx          

Need to know how we can add more volumes on this pool. I found the parm :

BROWSE BBBB.XXX.DMS.PARMLIB(POOLDSTG) - 01.1
Command ===>
********************************* Top of Data **
VOL=(vol1,vol2,vol3,vol4)
******************************** Bottom of Data
Need to make sure it is the right place to add a volume and if need to refresh Disk .                   

Resolution

To correct the problem, add volumes to the Archive pool you are using.  
Refer to Disk tech doc for  PARMLIB Specifications , and check the following rules.

Special Rules for POOLDEFS

In this Disk Parmlib member are a number of entries of the format: 'POOLNAME DATASETNAME'. Each poolname refers to a member which lists the volumes to be used for allocating the ARCHVOLS DATASETNAME to be created by the backup/archive job writing to Disk Archvols, which is indicated by the ARC0NAME Sysparm. To correct the problem, add volumes to that pool in this member.