ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
Job looping in workflow with U00011564 Inactive task 'TASKNAME' should start immediately, activation was kicked, Workflow activation will continue.
Article ID: 140687
Updated On:
Products
CA Automic Workload Automation - Automation Engine
CA Automic Workload Automation - Automation Engine
Issue/Introduction
After executing a workflow, a task within the workflow starts to loop with:
Job looping in workflow with U00011564 Inactive task 'TASKNAME' should start immediately, activation was kicked, Workflow activation will continue.
Environment
Release : 12.2, 12.3
Component : AUTOMATION ENGINE
Resolution
We have not been able to capture the root cause of this issue.
If this occurs, and in reproducable, please set:
TCP/IP=2
DB=3
Trace on the WP's from before the Activation of the Workflow until the issue presents itself. At that point, open a case with Support.
Feedback
Yes
No
Powered by
