Error messages displayed when entering "NetMaster : Command Entry" panel after Netmaster maintenance

book

Article ID: 140431

calendar_today

Updated On:

Products

CA CMDB for z/OS CA NetSpy Network Performance CA NetMaster Network Automation CA NetMaster Network Management for SNA CA NetMaster Network Management for TCP/IP CA NetMaster File Transfer Management

Issue/Introduction

Applied the following PTFs: SO09499, SO09541, SO09548, SO09755, SO09951, SO10079, SO09553, SO09566, SO09567, SO09577, SO09641, SO09882, SO09971, SO10138, SO09834, SO10120, SO10121, SO09323, SO09414, SO09841, SO07858, SO07858, SO07857, SO09324 and SO10844.

Now the following messages are returned just entering the"NetMaster : Command Entry" panel:

N10611 CURRENT PROFILE CHANGED.
N10102 AUTOHOLD COMMAND IS NOT VALID FOR ENTRY FROM THIS SOURCE.
N10804 PFK REQUEST INVALID FROM THIS ENVIRONMENT.
N10804 PFK REQUEST INVALID FROM THIS ENVIRONMENT.
N10804 PFK REQUEST INVALID FROM THIS ENVIRONMENT.
N10804 PFK REQUEST INVALID FROM THIS ENVIRONMENT.
N10804 PFK REQUEST INVALID FROM THIS ENVIRONMENT.
N10804 PFK REQUEST INVALID FROM THIS ENVIRONMENT.
N10804 PFK REQUEST INVALID FROM THIS ENVIRONMENT.
N03906 START OCSINIT PROCESSING COMPLETE. NCLID 000973
** END OF DELIVERED MESSAGES **

Cause

There is a NCL procedure (OCSINIT)  that sets up Operator Console Services (OCS) environment:

&CONTROL NOINTLOG

-PROFILE HOLD=999

-AUTOHOLD NOAUTO

-PF12 CS-

-PF13 D NET,CDRMS,SCOPE=ALL

-PF14 D NET,PENDING

-PF15 D NET,STATIONS,SCOPE=ALL

-PF16 D NET,CLSTRS,SCOPE=ALL

-PF17 PR PPO=NO

-PF18 PR PPO=YES


After having applied PTF SO09834 (INITIAL OCS COMMAND SUPPORT FOR COMMAND ENTRY), that PROC it's also invoked from Netmaster Command Entry also

Environment

Release : 12.2

Component : CA NetMaster Network Management for TCP/IP

Resolution

At the very beginning of the procedure, add:

&IF .&ZOCS NE .YES &THEN &EXIT

so it is not executed when not in OCS.

Additional Information

Other possible error, depending on the what is the content of the procedure:
N10648 PROFILE COMMAND INVALID FOR ENVIRONMENT.