UIM Admin Console grey out Static Alarm properties unable to edit

Products

• DX Unified Infrastructure Management (Nimsoft / UIM)

Issue/Introduction

Admin Console not allow to enable static alarm or edit other alarm properties. Its all grey out.

Environment

netapp_ontap probe.
This doc is applicable for other probes, such as snmpcollector probe.

Cause

"Publish Data" is not enabled.

Resolution

Enable "Publish data" and Static Alarm setting properties become editable.

Additional Information

For some probes, alarm is not triggered by probe itself, but triggered by baseline_engine probe.
"Publish data" is required for baseline_engine to trigger alarm.
See Article 43625 for details.
https://ca-broadcom.wolkenservicedesk.com/external/article?articleId=43625