In the CA Roscoe Started Task I see a multi-page dump generated. What do I do with this diagnostic?

Products

• Roscoe

Issue/Introduction

In the CA Roscoe Started Task I see a multi-page dump generated. What do I do with this diagnostic?

Environment

z/OS

Resolution

What you will see when CA Roscoe is started is a lot of messages advising you as to what features are active or inactive and also a small dump that looks similar to this:

 

1***** R O S C O E   -   R O S G B L 1 D *****
000C01000   D9D6E2C7 C2D3F1C4 F0F461F2 F561F1F6 F64BF040 40404040 F0F161F1 F361F1F7  ROSGBL1D04/25/166.0     01/13/17
 00C01020   F1F44BF3 F8404040 00002400 000008D8 00009000 00001000 00009000 00001000  14.38   .......Q................
 


This is simply a dump of the ROSGBL module currently in use by this CA Roscoe STC. This is totally normal and can be used by CA Support if there should be a problem within CA Roscoe that may require attention. The CA Roscoe STC should startup with a RC 00.