Dynam file and FTP
search cancel

Dynam file and FTP

book

Article ID: 136951

calendar_today

Updated On:

Products

Dynam for VSE Dynam VSE Option

Issue/Introduction

Have a Dynam disk file:

CAYD-2110
Data Set: AKK.HBOK.IFJOR
Type:     DISK          
                        
Ngens:             5 
Density:        CART 
Block Size:    OPT  
Record Length:    70   DYNAM/FI:       NO


Defined the file in stdlabel as  // DLBL AKKHBIF,'AKK.HBOK.IFJOR',,SD


Tried several definitions in CSI Tcp stack, eg:  

DEFINE FILE,PUBLIC='AKK.HBOK.IFJOR',DLBL=AKKHBIF,TYPE=SAM  - 
              READ=YES,RECFM=F,LRECL=78

I'm using windows command mode try GETing the file, without luck.                    

Always getting:

T213: IPF106E Sequential wrong length error has been detected. >
DLBL:AKKHBIF                                                   
T213: IPF107I Sequential record count of DLBL:AKKHBIF is 0   

Tried a lot of variations of recfm, lrecl etc.

Any advise?   

Environment

Release : 7.1

Component : CA-Dynam/D for VSE

Resolution

suggested to use Ditto to show the BLKSIZE. problem resolved using correct blksize