TLMS - how to reinstall the hooks

Products

• TLMS Tape Management

Issue/Introduction

How the OSI can be re-installed if they have been uninstalled by CAS9 using the following input:

PRODUCT(CA-TLMS/MVS) VERSION(TLC6) INIT(TLC6INIT) PARM(REINIT,OSI=NO)   for TLMS 12.6 

OR

PRODUCT(CA-TLMS/MVS) VERSION(TLE0) INIT(TLE0INIT) PARM(REINIT,OSI=NO)     for TLMS 14.0

Environment

Release : 12.6

Component : CA TLMS Tape Management

Resolution

When we running a cas9 with Product(CA TLMS) VERSION(TLC6) INIT(TLC6INIT) - PARM(REINIT,OSI=NO) the OSI are restored and in this case the tape activity will be not more recorded. To re-load / reinstall the OSI CAS9 should be run with Product(CA TLMS) VERSION(TLC6) INIT(TLC6INIT) - PARM(REINIT,OSI=YES). OSI - Specifies that the CA TLMS OSI is to be loaded, not loaded, or refreshed.

NO >>> Specifies that the CA TLMS OSI should not be loaded. YES >>> Specifies that the CA TLMS OSI will be loaded. REINIT >>> Specifies that the CA TLMS OSI should be refreshed. All tape processing MUST be stopped while the OSI is being reinitialized.