Is there a way to see the actual response to a WTOR?

Products

• Opera

Issue/Introduction

When replying to a WTOR, the response is suppressed, is there a way to see the actual response to a WTOR? 

Environment

Release: 3.1

Component:

Resolution

The ROUTECODE of 9 is IBM controlled but can be altered in the ACTION screens for Opera on an individual action basis.

When you update the action record there is a field that shows all the route codes that you have selected for messages to be generated.

It usually defaults to this:

Route Codes ----*----1----*----2

 1-64 ===> YYYYYYYYYYYYYYYY

In this line you will want to blank out the Y for route code 9, it will look like this:

Route Codes ----*----1----*----2

 1-64 ===> YYYYYYYY YYYYYYY

There is a blank in the column for route code 9.

PF3 from this screen and update the panel, then refresh the table on the screen.

F opera proc name,APREFR

The run your test, you should see the following type of response

IEE600I REPLY TO 0014 IS;Y in this case the response was a Y