LISTDMS Command Processor
search cancel

LISTDMS Command Processor

book

Article ID: 136181

calendar_today

Updated On: 09-20-2024

Products

Disk Backup and Restore - MVS DISK BACKUP AND RESTORE- ADD-ON OPTIO DISK BACKUP AND RESTORE

Issue/Introduction

Once the SO05344 PTF was applied and in spite that 

ISRDDN:

INS201   SHR,KEEP   >    DMSOSLIB DISK.CCUWLOAD
ZSD005   SHR,KEEP   >    PARMLIB  DISK.CCUWPARM 

and

If Parmlib not allocated in Logon Proc:

ADSUT099 2433 =========================================================
ADSUT099 2433 AN SVC 99 ERROR HAS OCCURRED IN -- DYNAMIC ALLOCATION    
ADSUT099 2433 ---------------------------------------------------------

The following messages are displayed during a DMSLIST:

ADSDM285 2629 DDNAME (PARMLIB ) IS ALREADY ALLOCATED, DEALLOCATE AND REENTER DMS REQUEST              ADSDM285 2629 DDNAME (PARMLIB ) DSN=DISK.CCUWPARM 

Environment

Release : Disk Backup and Restore 12.5

Resolution

The DMSSET job should be run against the loadlib being used and add the  ALTFILES and ALTPARMS parameters in the SET command.

Sample JCL:

//DMSSET  EXEC PGM=ADSMI002,PARM=ADSDM338     
//STEPLIB      DD DISP=SHR,DSN=YOUR.DISK.CCUWLOAD 
//SYSLIB        DD DISP=SHR,DSN=YOUR.DISK.CCUWLOAD
//ABNLDUMP DD DUMMY                           
//CMDPRINT  DD SYSOUT=*                        
                                              
//CMDPRINT  DD SYSOUT=*                        
//MSGPRINT  DD SYSOUT=*                        
//PARMLIB     DD DISP=SHR,DSN=YOUR.DISK.CCUWPARM 
//SYSPRINT   DD SYSOUT=*                        
//SYSUDUMP DD SYSOUT=*                        
//SYSIN           DD *                               
   SET FILESDSN=YOUR.PRIMARY.DISK.FILES,      
     PARMSDSN=YOUR.PRIMARY.DISK.PARMLIB,      
     ALTFILES,                                
     ALTPARMS                                 
//                                            

ALTFILES
Specify this simple parameter to allow users to allocate DDNAME=FILES to their ISPF/TSO session prior to executing Disk command processors. This allows users to use other than the default FILES data set.

ALTPARMS
Specify this simple parameter to allow users to allocate DDNAME=PARMLIB to their ISPF/TSO session prior to executing Disk command processors. This allows users to use other than the default parmlib data set.