Hyper-V probe templates

Products

• DX Unified Infrastructure Management (Nimsoft / UIM)

Issue/Introduction

The 3.10 or later versions of the probe allow you to create configuration templates. The templates are applicable to only the specific instance of the probe on the robot. Only existing profiles can be configured using templates.

https://techdocs.broadcom.com/us/en/ca-enterprise-software/it-operations-management/ca-unified-infrastructure-management-probes/GA/alphabetical-probe-articles/hyperv-microsoft-hyper-v-monitoring.html

Does that mean that we can't create a template through a superpack? Because we've created a template on a robot and we would like to create a superpack from it that included the template we just created.

I don't find how to do it, I don't see any <template></template> inside the cfg file. Dragging the probe to the archive does not create the template inside the .cfx so I'm assuming that it's impossible to create a template inside a superpack.

Environment

Release : 8.51

Component : UIM - HYPERV

Resolution

The templates are actually stored somewhere else, for Hyper-v, they are in: 

C:\Program Files (x86)\Nimsoft\probes\application\hyperv\bulk_config\raw_templates\ 

You may copy these to the same location on the other robots that have the probe and restart the probe.