Vmax probe - Not able to get the response in millisecond for storage array - UIM
search cancel

Vmax probe - Not able to get the response in millisecond for storage array - UIM

book

Article ID: 135510

calendar_today

Updated On:

Products

DX Unified Infrastructure Management (Nimsoft / UIM)

Issue/Introduction

Deployed 1.44 probe of VMAX and we are trying to capture response in millisecond for storage array and disks.
As per probe documentation we are supposed to capture response time in MS if solution enabler is above version 9.0.
But under discovered array we are not getting those parameters.

QOS_STORAGE_ARRAY_OVERALL_HEALTH_SCORE
QOS_STORAGE_STORG_READ_RESPONSE_TIME

Environment

vmax probe 1.44

Resolution

1. Open vmax probe in Raw Configure, add the following 2 parameters to the setup section.

apiversion = 90
unispherehost = (Specify device name where Unisphere for VMAX is running.)

2. Open vmax probe GUI, go to [General Setup] dialog, enter Unisphere credential to [User Name] and [Password]