DevTest Portal not showing what step of a test case is aborted on
Article ID: 135162
Updated On:
Products
Issue/Introduction
When monitoring tests in the Portal and seen a test case is marked as 'aborted', can't see what step is aborted on when drill down into the test case. Sometime, none of the steps show as abort but the test will show as abort.
Environment
Release : 10.x
Component : CA Application Test
Cause
In the Staging Document-->Reports-->Maximum number of errors and failures before test is stopped is set to 100 by default which cause the tests to Abort when error reaches more than 100.
Resolution
Changing the error count to more than 100 in the Staging Document-->Reports-->Maximum number of errors and failures before test is stopped should resolve the issue.
Additional Information
Check the Monitor Tests in Techdocs.
Coordinator log shows the below errors when errors cross the default number 100:
2019-07-25 18:39:41,600Z (13:39) [ServerRequestResponder 1] FATAL com.itko.lisa.history.AbstractWriteSupport - **********************************************************************************************
2019-07-25 18:39:41,600Z (13:39) [ServerRequestResponder 1] FATAL com.itko.lisa.history.AbstractWriteSupport - * The maximum error count (100) was exceeded; this includes warnings. Stopping the test!!!
2019-07-25 18:39:41,600Z (13:39) [ServerRequestResponder 1] FATAL com.itko.lisa.history.AbstractWriteSupport - * The maximum error limit is configured in the staging document's default report,
2019-07-25 18:39:41,600Z (13:39) [ServerRequestResponder 1] FATAL com.itko.lisa.history.AbstractWriteSupport - * where you can increase the limit if this volume of errors is expected behavior.
2019-07-25 18:39:41,600Z (13:39) [ServerRequestResponder 1] FATAL com.itko.lisa.history.AbstractWriteSupport - **********************************************************************************************
2019-07-25 18:39:46,742Z (13:39) [Sim check timer thread] INFO com.itko.lisa.coordinator.ReportGenerator - Finished com.itko.lisa.report.DefaultReportToDataModel@19408cee
Feedback
