After upgrading to UIM 9.1 PRD shows "source | origin" in host selection box instead of only "source"

Products

• DX Unified Infrastructure Management (Nimsoft / UIM)

Issue/Introduction

After upgrading to UIM 9.1 the Performance Report Designer (PRD) shows "source | origin" in the host selection box instead of only "source", as it used to be. 

In PRD When selecting "QOS Selection by Host" < UIM 9.1 showed only HOST, now it shows "source | origin" 

Is this an issue? Can this have any negative impact on reporting?

PRD on UIM 9.1:

PRD on < UIM 9.1

Environment

Release : 9.1.0

Component : UIM - UMP_QOSCHART

Resolution

This change only affects the way the host is displayed in Performance Report Designer the "QOS Selection by Host". In UIM 9.1, the host information is enriched (followed by) its ORIGIN.

The source and origin data are taken from the [S_QOS_DATA] table. Nothing has changed in UIM 9.1 in terms of  DB schema, and nothing has changed with regards to how the data is stored and how the probes send QOS definitions and messages. 

No issue should be generated by this change.