CA View - Wrong SARJCL1 Skeleton Being Used

Products

• View

Issue/Introduction

When SARBCH JCL is created to load SYSOUT from tape, an incorrect SARJCL1 skeleton is being used.  

What is needed to correct CVDEPENU(SARJCL1) for each database?

Environment

Release :

Component : CA View

Resolution

As part of the installation process, the CVDEPENU(SARJCL1) member needs to be modified, to run internal SARBCH functions, as it contains a bogus "//STEPLIB DD DSN=VIEW.SYSTEM1,DISP=SHR". 

 The statement should either be modified, commented out, or removed, based on what is done. 

 After whatever change is made, SARDBASE OLOAD needs to be run, to load the changed member to the View database.