IMS PSB Scanner continue processing in case of DBD not found
Article ID: 133767
Updated On:
Products
Issue/Introduction
Instead of issuing a CC=4 and a warning
message, the Repository PSB scanner ends with a CC=8
and does a rollback if a referenced DBD in
the PSBGEN syntax is not found in the Repository.
Any additional DBDs referenced that do exist in the
Repository are not processed.
Environment
Release : 7.2
Component : CA Repository Exchange for IMS
Resolution
Additional Information
A new parameter has been defined to the PSB
import program. The parameter has been added
at the end of the list so that if it is not
provided the behavior will remain as is.
Edit the PARMFILE DD and add a 13th parameter
as follows to implement the continue processing
switch
Y; 13 - CONTINUE SW
If Y is specified, the job will continue
processing if the event that a referenced
DBD is not found in the Repository. Upon
completion, the job will end with a CC=4
and a summary will be provided at the bottom
of the job output showing how many successfull
conversions were committed versus the total
number of PSBs encountered in the PSB Gen
Syntax.
Setting this new parameter to Y will require
that you set the existing 8th parameter to 'C'
C; 8 - COMMIT LEVEL C - COMMITS AFTER EACH PSB AND PCB
Feedback
