ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.

CA UIM - Exchange Probe Default Values

book

Article ID: 133052

calendar_today

Updated On:

Products

DX Unified Infrastructure Management (Nimsoft / UIM) NIMSOFT PROBES

Issue/Introduction

Are there some default baseline values available for the Exchange probe for exchange monitoring? I see several options but no baseline 'settings.'



Cause

- Question

Environment

Release: UIM 8.5.1 or higher

Component : Exchange Monitor

Resolution

There are no out-of-the-box/default baselines/baseline values, but once you enable baselines, whether static or dynamic, they will begin to be developed within the hour, then after a few weeks, e.g., 4 weeks you will have a statistically significant sample/baseline value. It can be displayed within USM in the PRD graphs or you can check the baseline values in the tables and use them to set intelligent thresholds for any IT asset/measurement.


Here is a very helpful article that answers most baseline questions:

https://community.broadcom.com/communities/community-home/librarydocuments/viewdocument?DocumentKey=d9ee83f3-8f22-4dfb-848a-9d8aecaa57ca


Powered by Wolken Software