HISRV install clist abends with S0C4

Products

• OPS/MVS Event Management & Automation

Issue/Introduction

When running prefix.CC2DJCL(install) the first time and  entered the CSI where the product is installed, along with the target and distribution zone names.  After getting the LINKLIST Update popup window, the CLIST abends with the following:

System abend code 0C4, reason code 00000004.

Abend in external subroutine RXGIMAPI.

***

The syntax error displayed after that points to line 1609:  Call "RXGIMAPI" "ADD"

Environment

HISRV 2.0

Cause

The hlq.CC2DLINK with the correct version of the necessary modules is not available to the CLIST

Resolution

The CC2DLINK (or CAILINK, depending on product and release) must be available in either the LINKLIST or the TSO STEPLIB (ISPLLIB).

It must also be APF authorized.

If this has been done and the problem persists, use TSO ISRFIND to determine all locations where  RXGIMAPI is located.

Example: 

  t

The results will show if the module is either missing or in multiple locations.

It may be possible that an old version is in the ISPLLIB or higher up in the LINKLIST.

Add, remove or adjust libraries so that the correct library is accessed by the INSTALL exec.