CADT103E when tape job ends in a static partition
search cancel

CADT103E when tape job ends in a static partition

book

Article ID: 132886

calendar_today

Updated On:

Products

Dynam for VSE Dynam VSE Option

Issue/Introduction

Just converted one of our systems from z/VSE 4.3 to z/VSE 6.2.  We are on Dynam 7.1.

When running tape jobs in a dynamic partition, it runs fine.

However, In a static partition, getting the CADT103E message and the tape drive remains attached to the guest.

Running under z/VM and using the DYNVM feature.

 

F5 0005 CADT031I *CLOSED* SYS001 SYS001=5D0 500363 xxxxxxxxx.yyyyyyy.zzzz    
       BLK=1209                                                            
F5 0005 CADT103E GETVIS FAILURE - UNABLE TO SEND DYNCLOSE COMMAND           
F5 0005 DUSPI012  DUMP FUNCTION ENDS. HIGHEST RETURN CODE IS: 00.           
F5 0005 DUSPI040  MAXBACK EXECUTION ENDS. HIGHEST RETURN CODE IS: 00.       
F5 0005 EOJ 161X157Z  MAX.RETURN CODE=0000

Resolution

1. Apply PTF RO51952 (for Dynam/VSE). 

2. There must be at least 10K of permanent PFIX for each partition that invokes the  Dynam/T VM interface.

// SETPFIX LIMIT=10K,PERM
// EXEC ....