ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
GSVX301E Command 'QW' not found or contains invalid syntax
Article ID: 132780
Updated On:
Products
SYSVIEW Performance Management
NXBRIDGE - SYSVIEW/ENDEVOR
Issue/Introduction
I have Quickref APF authorized and in the Linklist.
This is the error I am seeing:
GSVX301E Command 'QW' not found or contains invalid syntax.
This is the error I am seeing:
GSVX301E Command 'QW' not found or contains invalid syntax.
Environment
Release:
Component: SYSVW
Component: SYSVW
Resolution
Our QuickRef command, SDCQW, was in our SDC Site 3 Table.
I changed CNM4BPRM(XISPQWRF) to: SELECT CMD(%SDCQW PRM('&ZPARM')) NEWAPPL(QWIK) MODE(FSCR)
With the Quickref LOADLIB in the LINKLIST,
The command now works in SYSVIEW.
I changed CNM4BPRM(XISPQWRF) to: SELECT CMD(%SDCQW PRM('&ZPARM')) NEWAPPL(QWIK) MODE(FSCR)
With the Quickref LOADLIB in the LINKLIST,
The command now works in SYSVIEW.
Feedback
Yes
No
Powered by
