ADSDM175 message appeared in CA-DISK command after using IDB2.
search cancel

ADSDM175 message appeared in CA-DISK command after using IDB2.

book

Article ID: 132525

calendar_today

Updated On:

Products

Bind Analyzer for DB2 for z/OS SQL-Ease for DB2 for z/OS SYSVIEW Performance Management Option for DB2 for z/OS Plan Analyzer for DB2 for z/OS Subsystem Analyzer for DB2 for z/OS

Issue/Introduction



When the LISTDMS command of CA-DISK was issued on the ISPF panel after Sysview for DB2 was used in the same ISPF, the following error appeared.

ADSDM175 2056 PARAMETER CARD ENTERED THRU SYSPARMS DD STATEMENT IS IN ERROR
ADSDM175 2056 VERIFY THE FORMAT IS CORRECT, CARD VALUE IS ( DEFAULTS )

The LISTDMS command was able to be issued without a problem if the Sysview for DB2 hadn't been used before the LISTDMS command was issued. It seems that CA-DISK can't refer the CA-DISK's SYSPARMS after using the Sysview for DB2 because the required datasets for the Sysview for DB2 are allocated dynamically for the SYSPARMS DD when the Sysview for DB2 is used.
How should the LISTDMS command be done if the Sysview for DB2 is used before issuing that command?

Environment

z/OS, CA-DB2 R19.0, Sysview for DB2 R19.0, Sysview for DB2, R19.0, CA-DISK,

Resolution

The solution SO07831 was created on the Sysview for DB2 V19.0 for this problem.  (The problem number IDB2 2389 on release 19.0.)