ADSDM175 message appeared in CA DISK command after using Sysview for Db2

Products

• SYSVIEW Performance Management Option for DB2 for z/OS

Issue/Introduction

When the LISTDMS command of CA DISK was issued on the ISPF panel after Sysview Performance Management Option for
Db2 for z/OS (IDB2) was used in the same ISPF, the following error appeared:

ADSDM175 2056 PARAMETER CARD ENTERED THRU SYSPARMS DD STATEMENT IS IN ERROR
ADSDM175 2056 VERIFY THE FORMAT IS CORRECT, CARD VALUE IS ( DEFAULTS )

The LISTDMS command was able to be issued without a problem if the Sysview for Db2 had not been used before the LISTDMS command was issued.
It seems that CA-DISK cannot refer the CA DISK's SYSPARMS after using the Sysview for Db2 because the required datasets for the
Sysview for DB2 are allocated dynamically for the SYSPARMS DD when the Sysview for Db2 is used.
How should the LISTDMS command be done if the Sysview for Db2 is used before issuing that command?

Resolution

PTF solution SO07831 created for IDB2 r19
PTF solution SO08302 created for IDB2 r20