ALERT: Some images may not load properly within the Knowledge Base Article. If you see a broken image, please right-click and select 'Open image in a new tab'. We apologize for this inconvenience.
Release Automation Nexus Repository High Availability
Article ID: 132337
Updated On:
Products
CA Release Automation - Release Operations Center (Nolio)
CA Release Automation - DataManagement Server (Nolio)
Issue/Introduction
How can we configure Nexus Repository in (High Availability) HA mode?
Configuring Nexus repository in HA mode, in line to CA (Release Automation) RA installed in HA mode.
Configuring Nexus repository in HA mode, in line to CA (Release Automation) RA installed in HA mode.
Environment
CA RA: 6.4,6.5 or higher
Resolution
Repository Server - Nexus
When configuring the Management servers as highly available the repository server should be installed remote from the NAC and in a highly available configuration. The Nexus repository can be configured in an active passive configuration and in the event of a repository failure release automation can be reconfigured to redirect to the secondary node, details can be found on the Sonatype website for this configuration https://support.sonatype.com/entries/21451383-How-to-Set-up-Active-Standby-Failover.
When configuring the Management servers as highly available the repository server should be installed remote from the NAC and in a highly available configuration. The Nexus repository can be configured in an active passive configuration and in the event of a repository failure release automation can be reconfigured to redirect to the secondary node, details can be found on the Sonatype website for this configuration https://support.sonatype.com/entries/21451383-How-to-Set-up-Active-Standby-Failover.
Additional Information
CA Release Automation 5.x / 6.x Architecture and Implementation Best Practice Guide: https://communities.ca.com/docs/DOC-231165900-ca-release-automation-5x-6x-architecture-and-implementation-best-practice-guide
Feedback
Yes
No
Powered by
